TILT LOCK, MACHINE VICE 

Sizes -4", 6", 8"

Desc. - "ABL" Tilt Lock Machine Vice design is beamlike with two vertical and horizontal rails connected to the base. Available in Plain & Swivel Type.

TILT LOCK, MACHINE VICE

Sizes-4", 6"

Desc. - The specific advantage of this Vice is its ability to be set perpendicular to the base, thereby allowing right angle machining on the same machine setting.Sizes -1 Vi", 2 Vi", 3", A", 6" & 8"

PRECISION DRILL VICE

Sizes -1 Vi", 2 Vi", 3", A", 6" & 8"

Desc.- Moving jaw is plain & fixed is provided with one vertical & two horizontal 90° V-grooves. Horizontal and vertical V-groove in the stationary jaw allows holding of round job securely. 

COMPOUND SLIDING TABLE

Sizes - 6"x8", 8"x8", 10"xl 0", 12"xl 2" & 12"x 20"

Desc. - "ABL" Compound Sliding Table (With calibrated wheels& swivel graduated base). The surface table can swivel all round and 0° is marked to show the angular movement.

VERTICAL SLIDING TABLE

Sizes - 7" x 10"

Desc. - It is designed to fit on any Lathe, will enable you to mill slots, Key ways, grooves, flats, squares, also drilling at any angle.Sizes (in inches) - 18" x 5"

PROFILING, MILLING & SLOTTING SLIDE

Desc. - Profiling Milling & Slotting Slide (with Indexing Dividing Head & Tail Stock). Versatile for use with many machines such as milling, slotting, drilling or shaping machines. 

COMPOUND ANGLE TABLE

Sizes-9"x 7"Desc. - Movement on the table are indexed fully 360 degree in the Horizontal plane 90 degree in the Vertical. The table swivel on a ground steel spigot and can be locked in any position by steel clamp.

TILTING TABLE

[Swivel Base]

Sizes -5"x7", 7"xl 0", 10"xl 5“

Desc. - The table is set manually to the required Tilt and is locked in the set position by means of two locking clamps held through bolts. It can be adjusted by 45° on both right-hand and left- hand side. Useful accessory for setting work at an angle for milling or other operations.

ROTARY MILLING TABLE

Sizes - 6",8", 10", 12", 15", 18", 20"

Desc. - These are widely used for circular cutting, angle cutting, boring and spot facing with a milling machine. It works as an index centre in the vertical position, as well as conventional Rotary Table, graduated 360“ 

Scroll to Top